Summary

This document outlines power draw requirements for the iT100 timeclock.

The iT100 model tested was fully optioned iT100-AMT with AMP and Thermal modules to demonstrate the expected maximum wattage consumption for the device.  We advise not designing POE wattage for anything lower than these readings even though actual model/device used may consume less.  Suggested allocations for each iT100 are minimum 17 watts of power which will compensate for any degradation implied by wire length from switch to iT100.

Readings in various modes:

During Capture (Iris, Face, Card, Thermal):

• 53.4 VDC
• 0.320 AMPS
• 16.0 Watts

Bootup:

• 53.4 VDC
• 0.150 AMPS
• 8.0 WATTS

Standby (continuous mode – static wallpaper):

• 53.4VDC
• 0.205 AMPS
• 10.0 WATTS

Standby (continuous mode – movie wallpaper):

• 53.4VDC
• 0.220 AMPS
• 11.75 WATTS

Peak Draw:

• 53.5VDC
• 0.310 AMPS
• 16.6 WATTS

Average:

• 53.42 VDC
• 0.237 APMS
• 12.47 WATTS